Skip to content
Just nu 10% rabatt om ni handlar för över 1000kr!
Just nu 10% rabatt om ni handlar för över 1000kr!

Fixed cross-country skis with adhesive

Cleaning - We start by removing old glue

  1. Scrape off old adhesive tape with a sickle and a guide-track sickle, we recommend that you use a special adhesive tape sickle together with fiberlene cloth when scraping off the old adhesive. Then apply Wax Remover, making sure it doesn't get on the sliding surfaces. Wait for 30 seconds. Wax Remover dissolves remaining glue. Now you can wipe the attachment zone with Fiberlene. In the case of adhesives, a fibertex cloth is preferably used first. Then let the ski rest for 10 minutes so that all the wax evaporates.

    Cleaning the attachment zone from old adhesive tape:

Adhesive walling

  1. A tip is to preferably apply adhesive indoors in the heat.

  2. Rough up the attachment zone. Drag a piece of sandpaper (P80-P120) on the attachment zone of the ski so that the surface is roughened. This means that the wall adheres better to the surface.

  3. First put a very thin layer of hard glue at the bottom, for example Blue or Violet glue.

  4. Now you can put the sticker that is suitable for today's front. A tip is to preferably use a hot air gun or similar to heat the adhesive with. Avoid open flame on the skis as much as possible.

  5. Don't be afraid to hang up. Many put on too thin. (It is only when fresh snow is falling right at zero that you should be careful with thick layers of glue.)

  6. Let the skis cool down outside before you hit the trail. Important!

Back to how to pack cross-country skis